Blizzard-lighting wiCICLE Wireless DMX System (Rev B) Instrukcja Użytkownika Pobierz pdf (Strona 2)

POSSIBLE CONFIGURATIONS

The diagrams below show possible conﬁ gurations. Multiple receivers may

be used in any possible conﬁ guration.

OPTION 1. A transmitter (MALE XLR CONNECTOR) is connected to the

output of the controller, and a receiver (FEMALE XLR CONNECTOR) is con-

nected at the input of the ﬁ rst DMX ﬁ xture.

OPTION 2. A transmitter (MALE XLR CONNECTOR) is connected to the

output of a DMX ﬁ xture, and a receiver (FEMALE XLR CONNECTOR) is con-

nected to the input of the next DMX ﬁ xture.

OPERATION, TIPS & TRICKS

Each wiCICLE acts as both a transmitter and a receiver, depending on whether a DMX

source is applied to the integral XLR connector. This is an extremely powerful feature

of the system, however, it also requires 1 piece of due dilligence, and that is the re-

moval of extraneous DMX signals from your lighting rig BEFORE proceeding.

SO: BEFORE DOING ANYTHING ELSE, YOU SHOULD DISABLE ANY BUILT-IN

PROGRAMS IN THE FIXTURES YOU WISH TO CONNECT AND/OR SET THEM AS

SLAVES PRIOR TO RETURNING THEM TO DMX MODE (IF APPLICABLE). Most

ﬁ xtures contain a built-in automatic, sound active or custom program which

is designed to operate with the ﬁ xture NOT connected to a DMX chain.

Some of these programs will automatically run unless the ﬁ xture is set to slave mode.

These ﬁ xtures typically sense DMX automatically and switch to DMX mode upon re-

ceiving DMX signal (our Pucks do that!)

If you plug a wiCICLE “receiver” into an autosensing ﬁ xture set as a “master, “chances

are good that the wiCICLE “receiver” will begin transmitting the master program. Most

times, this is undesirable, and taking the two seconds to switch these programs off will

solve a lot of ails.

Got that done? Good! Then let’s proceed!

1. Power on the wiCICLE™ Transmitter and Receiver.

2. Press the button on the Transmitter to select the operating channel group. (The

system will store this setting for future use)

The 7-Color Status LED will change color to indicate the current channel group:

· GROUP 1: RED

· GROUP 2: GREEN

· GROUP 3: YELLOW

· GROUP 4: BLUE

· GROUP 5: VIOLET

· GROUP 6: CYAN

· GROUP 7: WHITE

3. Follow the same procedure on the Receiver to select the channel group.

4. Once both the transmitter and receiver(s) are both set to the same channel group,

connect the transmitter to the DMX controller or the DMX out of a ﬁ xture on your

DMX chain. Connect the receiver to the ﬁ xture you wish to control.

5. Once a DMX signal is provided to the transmitter, the status LED will blink RED

slowly until communication is established with the receiver. The status LED on the

receiver(s) will ﬂ ash GREEN slowly until communication is established.

6. Once the clearest channel is auto-selected, the status LEDs will blink quickly.

7. That’s It!

WE HAD THIS PAGE, SO WE FIGURED WE’D DRAW

YOU A PICTURE:

Antenna Housing & 1/2-wave

Antenna

Antenna ferrule & articulation

joint

Stainless Steel Housing

Recessed Selector Button

Status LED

3-Pin XLR Connector

(Male on transmitter, Female

on receiver model)

NOTE: “GROUP” number

also corresponds to the

“GROUP” setting on our

LightCaster™ wireless DMX

Transceiver.

SPECIFICATIONS

Model: wiCICLE™

Voltage: 5VDC, 1000ma

Supplied by 100~240V, 50/60Hz

AC Adaptor or directly by

wiCICLE ENABLED Fixtures and Equipment

Operating Band: 2.4Ghz ISM

Max Operating Range: 300 Meters (Line of Sight)

Max Transmission Power: 20dBm

Receiver Sensitivity: -94dBm

Data Input (Transmitter): 3-Pin Locking XLR Male

Data Ouput (Receiver): 3-Pin Locking XLR Female

Protocol: USITT DMX-512

Dimensions: 8.5”(L) x 0.75” (Diameter)

215mm x 19mm

Weight: .1 Lbs. / .05 kgs.

Duty Cycle: None

Working Position: Any Safe, Secure Position

Warranty: 2 Years

Speciﬁ cations and improvements in the design of this unit and this manual are subject

to change without any prior written notice.

1 2

Komentarze do niniejszej Instrukcji

Brak uwag

Blizzard-lighting wiCICLE Wireless DMX System (Rev B) Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Blizzard-lighting wiCICLE Wireless DMX System (Rev B)